Koszyk 0
Twój koszyk jest pusty ...
Strona główna » FPV » BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornikBetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornikBetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornikBetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornikBetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik
BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik

BetaFPV SuperD ELRS 2.4G Diversity Receiver oodbiornik

BetaFPV

Dostępność: Aktualnie niedostępny

Koszt wysyłki: od 0,00 zł

Kod producenta: 01070006_1

Stan magazynowy:

Stan produktu: Nowy

Gwarancja: Gwarancja produktów BETAFPV

Cena brutto: 98,60 zł

Cena netto: 80,16 zł

Najniższa cena z 30 dni to 98,60 zł

Raty PayU

Rata już od: miesięcznie

iLeasing
iRaty

Chwilowo niedostępny

Kupując ten produkt otrzymasz od nas 99 punktów które będziesz mógł wykorzystać na zakupy w naszym sklepie. Jest to 1% wartości zakupu. Dotyczy to tylko Klientów zarejestrowanych w naszym sklepie. Punkty nie zostaną naliczone na zakupy hurtowe B2B oraz za zakup produktów w promocji

  • Opis produktu
  • Recenzje produktu (0)

BETAFPV SuperD ELRS 2.4G is the world's first True Diversity Receiver that applies two antennas, dual receiver chains, and TCXO (temperature compensated crystal oscillator) tech, achieving super accurate frequency rate and excellent performance in extreme temperature environments. It greatly fulfills the requirements of reliability for long range flying, aerial photography, or FPV freestyle tricks

 

alt

Bullet Points

  • A true diversity receiver with two complete RF receiver chains (referring to PA+LNA+SX1280), based on the latest official ExprssLRS. It comes with ExpressLRS V3.0.0 firmware.
  • Ultralight weight only 1.1g without the antenna. The receiver board features a reasonable layout and is impeccably clean. Very easy to solder.
  • Two Dipole T antennas will create an omnidirectional signal for good signal transmission. Placing the antenna separately and vertically as far part as possible to get a better signal is recommended.
  • Not only it is used for FPV drones but also for FPV fixed-wing, or other FPV aircraft. It has superb performance in long range flying.

Specification

  • Item: BETAFPV SuperD ELRS 2.4G Diversity Receiver
  • MCU: ESP32 PICO D4, dual SX1280 (SX1281)
  • Antenna Connector: IPEX MHF 1/U.FL
  • RF Frequency: 2.4GHz (2400~2480MHz)
  • Telemetry Power: 20dBm (100mW)
  • Receiver Protocol: CRSF
  • Input Voltage: +5V DC @ “+” pad
  • PCB Size: 22mm*14mm
  • Weight: 1.1g excluding antenna

First True Diversity Receiver with TCXO

SuperD ELRS 2.4G Diversity Receiver is built-in a TCXO (temperature compensated crystal oscillator), which is shared by two RF chips for a super accurate clock source. The true diversity receiver including two RF chips and PA+LNA will generate a large amount of heat when working. With the high-quality TCXO, it can withstand extreme temperatures with no fear of heat and cold, continuously outputting accurate frequency for long range flight.

alt

BETAFPV ExpressLRS Receivers

SuperD ELRS 2.4G Diversity Receiver has dual RF receiver chains with two antennas, ensuring longer and more stable flying for FPV drones and RC airplanes. Choosing a suitable receiver to fly quadcopter or other RC models is very important. BETAFPV ExpressLRS Receivers including ELRS Lite, Nano, Micro, and the newest SuperD, greatly fulfill pilots' requirements for FPV flying.

  SuperD RX Micro RX Nano RX Lite RX
Weight 1.1g (RX only) 3.5g (RX only) 0.7g (RX only) 0.47g (Tower), 0.53g (Flat)
Antenna IPEX MHF + T antenna IPEX MHF + T antenna IPEX MHF + T antenna SMD ceramic antenna
MCU ESP32-PICO-D4, dual SX1280 ESP8285 ESP8285 ESP8285 
RF Chip Dual SX1280 + Dual PA SX128X SX1280 + PA, SX1276 + PA SX128X
Frequency 2.4GHz ISM 2.4GHz ISM 2.4GHz ISM, 915MHz (FCC), 868MHz (EU) 2.4GHz ISM
Telemetry Power 100mW 17mW 100mW 17mW
Serial Output Protocol CRSF PWM or CRSF CRSF CRSF
Model Type FPV Drone, Fixed-wing aircraft Fixed-wing aircraft, Helicopter, RC Cars, RC Boats FPV Drone Whoop Drone
alt

Diagram

The diagram for SuperD ELRS 2.4G Diversity Receiver. Below picture is the front for RX.

alt

The back of the RX is below. 

alt

SuperD receiver RGB status indication is shown below.

RGB Color Status Description
Rainbow Fade effect Power on
Green Quick flash WIFI upgrading mode
Red Quick flash No RF chip detected
Orange Double flash Binding mode
Orange Triple flash Connected, but mismatched model-match configuration
Orange Slow flash Waiting for connection
  Solid on Connected and color indicates packet rate

The RGB light color corresponding to the packet rate is shown in the figure below.

alt

Note: F1000 and F500 are packet rates in FLRC mode, providing faster modulation and lower latency, but at the same time having shorter reception distance than normal Lora mode. This mode is great for racers.

D500 and D250 are packet rates in DVDA (Deja Vu Diversity Aid) mode. This mode works at the F1000 data packet rate of FLRC mode, providing better link connection in the case of complex interference by sending the same data packet multiple times. D500 and D250 indicate that the same data packet is sent twice and four times respectively

 

Configuration & Bind

ExpressLRS uses the Crossfire serial protocol (AKA CRSF protocol) to communicate between the SuperD diversity receiver and the flight controller board. Take the flight controller using the Betaflight firmware as an example to introduce its wiring and port configuration. 

The connection between the SuperD diversity receiver and the flight controller is shown in the figure below

alt

Connect the flight controller to the Betaflight Configurator for basic configuration. First, on the "Port" page, enable the flight controller serial port (take UART1 as an example) as "Serial Rx". 

alt

On the configuration page, set Receiver Mode to Serial (via UART) and Serial Receiver Provider to CRSF.

alt

The default firmware of the SuperD diversity receiver uses the ExpressLRS V3.0.0 protocol and has no preset binding phrase.  Therefore, the firmware version of the transmitter module must be ExpressLRS V3.0.0 or later versions. Both the receiver and transmitter module should not have any binding phrase.

  • Power on and off the SuperD diversity receiver three times with 1 second between each interval continuously to enter the Binding Mode.
  • RGB indicator flashes twice quickly on the SuperD diversity receiver, indicating that the receiver is now in Binding Mode.
  • Configure remote control or transmitter module to bind with the receiver; If the receiver RGB indicator is solid on, this indicates that the receiver has successfully bound.

Note: After binding once, the receiver will remember the autosaved binding phrase and device. Further restarting of the device will be bound automatically without the need for a rebinding process.

When binding the receiver, the duration for powering on/off should be 1 second each time, making sure the RGB not lighting.

If you would like to flash the official ExpressLRS V3.0.0 firmware for SuperD receiver, please upgrade ExpressLRS Configurator to V1.5.2. Select the target device "BETAFPV SuperD 2.4GHz RX"

alt

FAQ

Know More About ExpressLRS

ExpressLRS is an open-source RC link for RC applications. Everyone could find this project on Github or join the discussion in Facebook Group.

alt

Package

  • 1 * SuperD ELRS 2.4G Diversity Receiver
  • 2 * BETAFPV Dipole T Antenna
  • 1 * Pin Header
  • 1 * 30AWG Silicon Wires (1 black, 1 red, 1 white, 1 yellow)
  • 1 * User Manual
alt

Nikt jeszcze nie napisał recenzji do tego produktu. Bądź pierwszy i napisz recenzję.

Napisz recenzję do tego produktu, a otrzymasz od nas 100 punktów które będziesz mógł wykorzystać na zakupy w naszym sklepie. Dotyczy to tylko Klientów zalogowanych i zarejestrowanych w naszym sklepie.

Tylko zarejestrowani klienci mogą pisać recenzje do produktów. Jeżeli posiadasz konto w naszym sklepie zaloguj się na nie, jeżeli nie załóż bezpłatne konto i napisz recenzję.


Klienci zakupili także
Pozostałe produkty z kategorii
Ładowarka SkyRC Q200 4 kanały

Ładowarka SkyRC Q200 4 kanały

629,00 zł brutto511,38 zł netto
Silnik BetaFPV 1404 4500KV

Silnik BetaFPV 1404 4500KV

85,00 zł brutto69,11 zł netto
Śmigła Ethix P4 Candy Cane Prop 5,1" (2CW+2CCW)-Poly Carbonate.
szt. Do koszyka
DJI Goggles 2 - Power Cable

DJI Goggles 2 - Power Cable

123,00 zł brutto100,00 zł netto
szt. Do koszyka
Nadajnik Video VTX TBS Unify Pro 5G8 HV 25-800mW (SMA)
szt. Do koszyka
alt
 
alt
USTAWIENIA PLIKÓW COOKIES
W celu ulepszenia zawartości naszej strony internetowej oraz dostosowania jej do Państwa osobistych preferencji, wykorzystujemy pliki cookies przechowywane na Państwa urządzeniach. Kontrolę nad plikami cookies można uzyskać poprzez ustawienia przeglądarki internetowej.
Są zawsze włączone, ponieważ umożliwiają podstawowe działanie strony. Są to między innymi pliki cookie pozwalające pamiętać użytkownika w ciągu jednej sesji lub, zależnie od wybranych opcji, z sesji na sesję. Ich zadaniem jest umożliwienie działania koszyka i procesu realizacji zamówienia, a także pomoc w rozwiązywaniu problemów z zabezpieczeniami i w przestrzeganiu przepisów.
Pliki cookie funkcjonalne pomagają nam poprawiać efektywność prowadzonych działań marketingowych oraz dostosowywać je do Twoich potrzeb i preferencji np. poprzez zapamiętanie wszelkich wyborów dokonywanych na stronach.
Pliki analityczne cookie pomagają właścicielowi sklepu zrozumieć, w jaki sposób odwiedzający wchodzi w interakcję ze sklepem, poprzez anonimowe zbieranie i raportowanie informacji. Ten rodzaj cookies pozwala nam mierzyć ilość wizyt i zbierać informacje o źródłach ruchu, dzięki czemu możemy poprawić działanie naszej strony.
Pliki cookie reklamowe służą do promowania niektórych usług, artykułów lub wydarzeń. W tym celu możemy wykorzystywać reklamy, które wyświetlają się w innych serwisach internetowych. Celem jest aby wiadomości reklamowe były bardziej trafne oraz dostosowane do Twoich preferencji. Cookies zapobiegają też ponownemu pojawianiu się tych samych reklam. Reklamy te służą wyłącznie do informowania o prowadzonych działaniach naszego sklepu internetowego.
ZATWIERDZAM
Korzystanie z tej witryny oznacza wyrażenie zgody na wykorzystanie plików cookies. Więcej informacji możesz znaleźć w naszej Polityce Cookies.
USTAWIENIA
ZAAKCEPTUJ TYLKO NIEZBĘDNE
ZGADZAM SIĘ